GRAPHTEC WR300 - Trigger Specifications; Software Specifications

To Next Page

To Previous Page

Specifications

6-5

Trigger Specifications

Software Specifications

Item Details

Time gate OFF, Relative time, Absolute time

Action Single, Repeat

[Start condition] source OFF: Start triggered by pressing the START key

Internal: Start triggered by a combination of measured signals

Manual: Start triggered by pressing the TRIGGER key

External: Start triggered by a TRIGGER IN signal from the remote connector

[Stop condition] source OFF: Stop triggered by pressing the STOP key

Internal: Stop triggered by a combination of measured signals

Manual: Stop triggered by pressing the TRIGGER key

External: Stop triggered by a TRIGGER IN signal from the remote connector

Time: Stops measurement at preset time

Combination Level OR, Level AND, Edge OR, Edge AND

Judgment mode Edge: Rise time (↑), Fall time (↓)

Level: H (High), L (Low)

Window: IN, OUT,

OFF

Level –100% to +100% of setting range in 1% steps

Trigger Counter (when the Number of times: 1 to 255

Combination setting is Level) Filter: Product of the Sampling Interval and the Number of Times settings (can only be set

when the Function setting is Memory).

Pretrigger Internal memory: 0% to 100% in 1% steps

PCMCIA card, HDD: On/Off

Logic trigger Pattern: H (High), L (Low), X (Don't care)

Judgment mode: When the pattern is matched

Item Details

Compatible operating system Windows 2000/XP

Functions Measurement conditions setting, data measurement, file conversion, report creation (option)

Measurement condition settings WR300/310 control, communication conditions setting

Measurement function Recorder mode

Display format Y-T

Display direction Horizontal scroll

No. of display zones Zone specification

Digital display Digital display of measured values for up to 8 channels on left-hand side of screen