5-16
Application Software
5.7 Measurement Parameter Setting Procedures
Amplifier Settings
The Amp Settings window enables the setting of the amplifier parameters.
Click "Amp Settings" in "Input Settings" in "Settings" on the menu bar, or click to display the Amp Settings
window as shown below. Set the parameters, click "Apply", and then click "OK".
CHECKPOINT
The Amp Settings window contains the same details as those shown on the WR300 monitor screen. For details, see
Section 3.2, "Amp Settings".
CH * to CH * ................... Displays the amplifier units mounted in the WR300. Select the number of the
amplifier unit to be set.
Name ............................. Sets the names for each channel.
CHECKPOINT
The name entered must fit within the input box. The name settings are reset to the default
settings if the network connection is reset. This window is used to change the names
temporarily.
Input ............................... Sets the input type for each channel. The input types that can be set will vary
depending on the type of amplifier installed.
Range ............................ Sets the range for each channel. The ranges that can be set will vary depending on
the type of amplifier installed.
Filter ............................... Sets the filter for each channel. The filter types that can be set will vary depending
on the type of amplifier installed.
Misc................................ Additional settings may be required according to the type of amp installed. Specify
the additional settings as necessary.
WR3-V amp, WR3-M amp, WR3-FV amp
Zero point auto adjustment, zero point adjustment reset, zero point voltage
value
WR3-DCB amp
Auto balance, rated output, setting of calibration values
To Next Page
Loading...