GRAPHTEC WR300 - 2.5 Control Panel Part Names and Functions

Checks and Preparation
2-5
2.5 Control Panel Part Names and Functions
Direct Channel Operations
MODE
CLOSE
CANCEL
MENU
EXE.
MONITOR
ENTER
MEAS.
RANGE POSITION
CH
FILT. VERNI. AUTO ZERO
LOCAL
TRIGGER
DISK
CURSOR
PRINTER
COPY
LIST
FEED
REPLAY
START
STOP
mm/s
mm/m
mm/h
125102050V1V2 UNIT
12345678
910111213141516
(2)
(7)
(3)
(1)
(6)
(5)
(4)
(1) CH keys ......................... Select the channel number(s) for which measurement conditions can be
specified.
(2) MEAS. key ..................... Selects the input coupling status.
(3) RANGE keys ................. The [ ] and [ ] keys select the measurement range.
(4) POSITION keys ............. The [ ] and [ ] keys specify the recording position. The position can also be
specified by using the MENU functions when the relevant menu is displayed.
(5) FILT. key ........................ Selects the filter mode.
(6) VERNI. key .................... Selects the Vernier function.
(7) AUTO ZERO key ........... Automatically moves the recording position to the origin point (cannot be used
for temperature measurement).
Printer Operations
MODE
CANCEL
MENU
EXE.
MONITOR
ENTER
MEAS.
POSITION
CH
FILT. AUTO ZERO
LOCAL
TRIGGER
DISK
CURSOR
PRINTER
COPY
LIST
FEED
REPLAY
START
STOP
mm/s
mm/m
mm/h
125102050V1V2 UNIT
12345678
910111213141516
(2)
(1)
(3)
(4)
(5)
(6)
(7) (8)
CLOSE
RANGE
VERNI.
(1) PRINTER key ................ Press this key to initiate recording of measured data.
(2) PRINTER LED ............... Lights when recording to chart paper is enabled.
(3) COPY key ...................... Press this key to make a copy of the screen display.
(4) LIST key......................... Press this key to print a list of the currently selected measurement conditions on
chart paper.
(5) FEED key ...................... Press this key to advance the chart paper, without recording measured data.
(6) CHART SPEED keys ..... Press one of these keys to set the chart speed to the value indicated on the key.
(7) V1/V2 keys .................... Press V1 or V2 to change the chart speed to the chart speed set for V1 or V2.
(8) Unit key.......................... Use to specify the chart speed as mm/s, mm/min, or mm/hr.