GRAPHTEC WR300 - Page 21

To Next Page

To Previous Page

2-6

Checks and Preparation

Detailed Setting Operations

MODE

CANCEL

EXE.

MONITOR

ENTER

MEAS.

POSITION

FILT.

AUTO ZERO

LOCAL

TRIGGER

DISK

CURSOR

PRINTER

COPY

LIST

FEED

REPLAY

START

STOP

mm/s

mm/m

mm/h

125102050V1V2

UNIT

12345678

910111213141516

(9)

(10)

(1)

(2)

(3)

(4)

(11)

(5)

(6)

(7)

(8)

(12)(12)

RANGE

VERNI.

(1) MODE key ..................... Selects the measurement mode. Each time you press this key, the

measurement mode switches between RECORDER and FFT modes. It is also

used to exit the REPLAY mode.

FFTRECORDER

(2) CLOSE key .................... Closes the setting window.

(3) CANCEL key.................. Cancels the selected setting(s) displayed in each setting window.

(2) + (3) KEY LOCK ............ Hold down the (2) CLOSE key and the (3) CANCEL key simultaneously for at

least three seconds to enable key lock status. To cancel key lock status, hold

down the same keys again for at least three seconds.

(4) MENU key ..................... Switches through the setting windows.

(5) MONITOR key ............... Displays the settings for each channel on the monitor.

(6) EXE. key ........................ Press this key when "Press EXE." is indicated as a selection in a setting mode.

(7) REPLAY key .................. Replays the captured data.

(8) LOCAL key .................... Press this key to switch from online status to offline status.

(9) TRIGGER key................ When the trigger mode is set to MANUAL, press this key to activate the trigger

and initiate measurement.

(10) CURSOR key .............. Used for data analysis when REPLAY data is displayed.

(11) ENTER key ..................

Press this key when "Press ENTER" is indicated as a selection in a setting mode.

(12) Direction keys .............. These keys move the cursor on the screen in the direction indicated. For fast

cursor movement, use the [ ] and [ ] keys.

Measurement Status Operations