GRAPHTEC WR300 - Monitor Part Names and Functions; Direct Settings (Selecting the Measurement Parameters)

2-4
Checks and Preparation
2.4 Monitor Part Names and Functions
(1) Measurement mode display area(11) Channel annotation area
(2) Date/time display area
(3) Chart speed display area
(4) Simplified message display area
(5) Monitor area
(7) Waveform/settings window display area
(9) Scale lower limit
(8) Span display area
(6) Position display area
(10) Scale upper limit
(1) Measurement mode display area .. Displays the measurement mode currently set.
(2) Date/time display area .................. Displays the current date and time. Moreover, displays IRIG time code
information when IRIG settings have been enabled.
(3) Chart speed display area.............. Displays the chart speed currently set.
(4) Simplified message display area .. Displays the system status.
For example, "Awaiting trigger" is displayed when waiting for a trigger
signal.
(5) Monitor area ................................. Displays the input signal values for each channel.
(6) Position display area .................... Displays the input signal positions for each channel.
(7) Waveform/settings window display area
................................................. Displays the measurement signal waveforms. The menu windows are
also displayed when the MENU key is pressed.
(8) Span display area ......................... Displays the zone width (span) for the range set.
(9) Scale lower limit............................ Displays the lower limit of the scale set for each channel.
(10) Scale upper limit ......................... Displays the upper limit of the scale set for each channel.
(11) Channel annotation..................... Displays the user annotation set for each channel.
Direct Settings (Selecting the Measurement Parameters)
(2) MEAS
(1) CH
(3) RANGE
(4) FILT
(1) CH keys: Press to select the channel(s) for which measurement conditions can be specified.
(2) MEAS. key: Selects the input coupling status for each preamplifier. Each time you press this key, the
input coupling status changes.
(3) RANGE [ ] and [ ] keys: Select the measurement range for each channel. Each time you press a
RANGE key, the measurement range changes.
(4) FILT. key: Selects the filter mode. Each time you press the FILT. key, the filter mode changes.