2-18
Checks and Preparation
2.11
Connecting the Power Cable and Turning on the Power
This section describes how to connect the power cable and turn on the power. The connection method will
vary depending on the type of power supply used.
Connecting to an AC Power Supply
(1) Insert the AC cable's female plug into the recorder's AC connector, and then insert the male plug into an
electrical socket.
(2) To operate the recorder on the AC power supply, turn on the main unit's AC POWER switch.
CHECKPOINT
• Be sure to connect the GND terminal while referring to the "Safety Precautions" at the front of this manual. It must
also be connected when connecting an external device so that both the recorder and that device will share the
same GND level.
• The WR300/310 is designed to switch automatically between 100 VAC and 200 VAC power supplies. Make sure
that the power cable you use has the correct rating.
To Next Page
Loading...