5-28
Application Software
5.10
Opening Captured Data Files and Saving WR300-Captured Data to a PC
Opening Captured Data Files on a PC
Click "Open" in "File" on the menu bar or click , select the directory and display file type, and then select
the file to be converted. The file specification window is displayed. The files that can be selected are gbd
data files created using a WR300 series device. Other files cannot be selected. The waveform (selection
range) window may not be displayed if there is insufficient virtual memory.
CHECKPOINT
To display more than one item of data, click "File" → "Open" and repeat this operation.
Extensions
" .gbd" : Memory data or data selected by cursors and saved
" .gdt" : Data directly written to the hard disk or PCMCIA or data measured in real time
" .gmd" : Data displayed on the PC and saved
Saving Data Captured in the WR300 to a PC
(1) Select "File Transfer" in "Transfer" on the menu bar to display the File Select window.
(2) Select the capture destination on the left-hand side of the screen. To select, double-click the capture
destination drive or folder.
(3) Select the file to be acquired in the right-hand side of the screen, and click on "Get File".
(4) Set the data capture destination and click "OK" to start transferring the data. The data will be saved
using the name stored in the WR300. This will be the capture block number when saving to memory.
To Next Page
Loading...