Checks and Preparation
2-13
2.9 Loading Chart Paper
CHECKPOINT
• The thermally sensitive surface of the chart paper is the outer surface for roll paper, and the inner surface for Z-fold
paper. Data will not be recorded if the paper is loaded in reverse.
•
The last meter of the chart paper is marked with a red line to indicate that the end of the chart paper is near. In addition,
the remaining length of the chart paper is printed in meter units, at 10-cm intervals, along the edge of the chart paper.
Loading Roll Paper
(1) Lower the printer open lever and open the printer cover. Insert the roll paper bobbins into both sides of
the roll paper's core.
Bobbins
100-mm width Roll Paper: PR230
200-mm width Roll Paper: PR231A
(2) Load the roll in the recorder.
WR300-8/WR300-16
WR310-8/WR310-16
200-mm width
WR300-4
100-mm width
High Temperature
Right after recording, the thermal head may be very hot and cause burns or other injuries if accidentally touched.
Before replacing the chart paper, allow the thermal head to adequately cool down.
CAUTION
When loading the chart paper, take care not to damage the thermal head. Recording will not be performed
correctly if the thermal head is damaged.
(3) Pull the leading edge of the paper out of the printer cover's paper outlet, and then close the printer cover
firmly.
WR300-8/WR300-16
WR310-8/WR310-16
200-mm width
WR300-4
100-mm width
(4) Press the FEED key to feed the paper approximately 10 cm, and make sure that there is no slack in the
paper before starting measurement.
To Next Page
Loading...