GRAPHTEC WR300 - Execute Operations

Recorder Mode
3-37
3.19 Execute Operations
(1)(2)(3)(4)
(5)
(6) (9) (10)(7)(8)
(11)
XY Setting
[Action]:Performs various operations for waveforms, such as expansion, compression, printout, and
calculation.
(1) Expansion/Compression
............................. Expands or compresses the display of waveforms being replayed.
Between Cursors: Expands or compresses the cursor-defined segment of the
waveform display to fit the screen's width.
Fixed Scale : Expands or compresses the waveform by the ratio selected from
the choices below.
Expansion : Can be set to any integer from 1 to 10.
Compression : Can be set to any fraction with a numerator of 1 from 1/1 to 1/
1000.
Free Scale : Expands or compresses the waveform by the desired
magnification ratio from 1/1000 to 10. The User Scale value is
specified as the time unit per division.
(2) Printer Output (Between Cursors)
............................. This parameter prints the cursor-defined segment of the waveform display onto
chart paper. This function is only available when the cursor mode is set to "Dual".
(3) Printer Output (All Data)
............................. This parameter prints all waveform data being replayed onto chart paper.
(4) Save to Disk (Between Cursors)
............................. Saves the cursor-defined segment of the waveform enclosed again to the internal
hard disk or PCMCIA card. This function is only available when the cursor mode is
set to "Dual".
[XY Display]: Displays the captured data in XY format when XY Display is selected
(5) XY Settings ............... Specifies the parameter settings for X-Y display.
(6) Size........................... Sets the display screen size to Narrow or Wide.
(7) Grid ........................... Sets the grid.
Fine : Displays the main grid and sub-grid lines.
Coarse : Displays only the main grid lines.