Checks and Preparation
2-11
2.7 Installing or Removing an Amp
This section explains the procedures for installing or removing an analog amp. To remove an amp, perform
the installation procedure in reverse. Moreover, when pulling out an amp, be sure to grasp the amp panel to
pull the amp out and off.
CAUTION
• Always turn off the recorder before installing or removing an amp.
• Whenever handling an amp, pay due attention to avoid static electricity and so on.
(1) Remove the setscrews that secure the analog amp slot's cover and then remove the cover.
(2) Select an amp suitable for the type of measurements to be performed and insert it in the slot by aligning
the amp's guide with the main unit guide.
Amp guide
Main unit guide
(3) Secure the amp in place by tightening the setscrews.
To Next Page
Loading...