3-30
Recorder Mode
3.13 Customize Settings
(5) (6) (7)
(1)(2)(3)(4)
(1) Language.................. Sets the WR300/310's display language. If you change the language, perform the
Execute Settings operation to register the change.
Japanese, English (US), English (UK), French
CHECKPOINT
The only difference between English (US) and English (UK) is the way the date is
displayed.
(2) 100m Z-fold Chart Unit
............................. This function can be specified as Use or Do not use.
(3) Echo Back ................ This function can be specified as Enable or Disable. If you change the setting,
perform the Execute Settings operation to register the change.
(4) Trigger Level Setting
............................. Displays the setting in % units, and also enables the display to be switched to
display voltage units.
CHECKPOINT
If you use temperature ranges for the M amp channels, the settings will automatically be
displayed as temperature units.
(5) DCB AMP Calibration Mode
............................. This sets the type of signal when performing calibration for the strain amp. You can
select either Strain or Voltage. If you change the setting, perform the Execute
Settings operation to register the change.
(6) Room Temp. Compensation
............................. This parameter enables room temperature compensation settings when
thermocouples are used. You can select either Internal or External room
temperature compensation. The Internal setting is normally used. If you change the
setting, perform the Execute Settings operation to register the change.
(7) Execute Settings....... Executes any changes made to settings on the Customize Settings menu.
CHECKPOINT
If you change any of the settings in this window, be sure to perform the Execute Settings operation to register the
change, and then turn the power off and on again. If a change is not registered, the setting will be not changed.
To Next Page
Loading...