5-14
Application Software
OPS023 Transfer Settings
The procedure for setting the transfer (communication) parameters is described below. The IP address for
the WR300 when used on a network should be determined in consultation with the network administrator.
(1) Setting window display
Select the interface to be used in " Interface" in "Transfer" on the menu bar.
(2) Setting window display
Select "Device Registration" in "Transfer" on the menu bar or click with the mouse to display the
registration window shown below.
(3) Settings
Click "Add" to display the following TCP/IP Settings window. Set the items required, and click "OK" to
close the TCP/IP Settings window.
Host Name .............. Sets the host name for the WR300 connected. (Any name can be entered.)
IP Address............... Sets the IP address for the WR300 connected. (When using network)
Port Number ........... Sets the port number for the WR300 connected. (When using network)
Device ID ................ Sets the ID number for the WR300 connected. (When using USB)
CHECKPOINT
• Checking the "Specify address with host name" box allows the WR300 to be specified using the host name
instead of its IP address. The host name and IP address must be registered beforehand in order to use this
function. Consult with the network administrator.
• The WR300 IP address and port number can be checked on the WR300 Option Settings window if the optional
monitor is installed. To check, clear the "REMOTE" indicator, if it is illuminated, by pressing the "LOCAL" key on
the WR300.
(4) Setting registration
If the details displayed on the screen are correct, click "OK" to close the registration window. If the
details have not been set correctly, select the particular parameters and either click "Edit" to reset them,
or click "Delete" to delete them. Then click "Add" again to set the new settings.
To Next Page
Loading...