GRAPHTEC WR300 - Setting the IP Address and Device ID

Application Software
5-9
5.5 Setting the IP Address and Device ID
The WR300 Configuration Tools window is used to set the IP address, Sub Net Mask, Port Number, and
Device ID.
• These can also be set using the WR300. For details, see Section 3.12, "Option Settings".
• IP Address : Used when measuring via a network.
• Sub Net Mask : Used when measuring via a network.
• Mac Address : Used when setting the Mac Address.
• Port Number : Used when measuring via a network.
• Device ID : Used when measuring via USB.
• Firmware version : Used to check each firmware version.
CHECKPOINT
• When setting the IP address and port or device ID using the WR300 Configuration Tools, the WR300 should be
connected directly to the PC using a USB cable.
• When using more than one WR300, they should be connected separately, and not via a USB hub.
(1) Connect the WR300 to the PC using a USB cable.
(2) Select "Start" → "Programs" → "OPS023" → "Wr Config" to launch the WR300 Configuration Tools and
display the window as shown below.
(3) LAN settings
Click "Read" to display the current setting. To set a new IP address, Sub Net Mask and/or Port Number,
enter the new setting(s) and then click "Apply".
(4) USB settings
Click "Read" to display the current setting. To set a new Device ID, enter the new Device ID and then
click "Apply".
(5) Firmware Version
Click "Read" to display the Main and Printer version numbers. Use this function to check the version
number(s) of your equipment.
(6) After setting, exit from WR300 Configuration Tools.