3-18
Recorder Mode
3.6 Data Replay Settings
(1) (9)(3) (4) (5) (3) (4) (5)
(2)
(8)(7)(6)
When the Capture Destination is Memory When the Capture Destination is Disk
[Replay Source Settings]: Specifies the capture destination of the measured data.
(1) Replay Source .......... Selects the source for loading measured data.
Memory : Loads captured data from the WR300/310's internal memory.
Disk : Selects the replay source when the replay data is located within a hard
disk (WR310 only) or a PCMCIA card.
(2) Replay Block............. This parameter, which can only be set when the Replay Source setting is Memory,
selects the Block No. that contains the data to be loaded. Any block that is
displayed in solid green can be selected. After a block is selected by this
parameter, it becomes red.
[Data Save Conditions]: Displays the conditions that were used to save the data being loaded. The
conditions appear as soon as the Replay Block setting is specified. The displayed
data cannot be changed.
(3) Sampling Interval ...... Displays the Sampling Interval setting used to save the data being loaded. The
displayed data cannot be changed.
(4) Time Scale ................ Displays the time scale used when the data was captured.
(5) No. of Data ............... Displays the No. of Data points used to save the data being loaded. The displayed
data cannot be changed.
[Replay View Settings]: Sets the display conditions for replaying captured data.
(6) Replay CH ................ Selects the source channel(s) for loading data.
All CHs : Loads the data of all channels
Selected CH(s) : Loads the data of only the specified channel. If you select
Selected CH(s), also specify the target channel number at the CH
parameter.
(7) Output Ratio ............. Selects the magnification ratio of the time axis for use in data replay.
x 1/10, x 1/8, x 1/5, x 1/4, x 1/2, x 1, x 2, x 4, x 5, x 8, x 10, Screen Width
CHECKPOINT
The Screen Width setting enlarges or reduces the data so that it will all fit into the 10 div
screen for viewing.
To Next Page
Loading...