3-20
Recorder Mode
3.7 Format Settings
(4)(5)
(10)
(6) (8)(7) (9)(1)(2)(3)
(1) Grid ........................... Selects the grid pattern for use when displaying and plotting waveforms. The grid
patterns that can be selected differ according to the display mode set at the Record
Settings window.
None
10mm
10mm fine
10mm
5mm
5mm fine
5mm
5mm
5mm fine
5mm
10mm
10mm Coarse
10mm
(2) Envelope................... This parameter can only be set when the Function setting is Direct. Selects the On/
Off status of the Envelope function.
TIP
When fast-frequency signals are concurrently measured with slow-frequency signals,
recording on chart paper products dark results for fast-frequency signals and hardly
legible results for slow-frequency signals. If this happens, enable this function to increase
the legibility of slow-frequency signals.
(3) Priority Display.......... Selects the On/Off status of the Waveform Priority Display function to determine
whether or not to place priority on a certain channel during waveform display.
TIP
When On is selected as the Priority Display setting, a submenu appears for specifying the
priority channel number during waveform display (Priority CH).
(4) Priority CH ................ This parameter, which can only be set when the Priority Display setting is On,
selects the target channel number for priority display.
(5) Zone Preset .............. Sets the waveform display and recording formats.
Preset 1 to 7 : Display and recording are performed in the fixed formats. After
selecting your preferred preset, the Zone specification items are
displayed.
Custom : Lets you specify the display and recording formats when you make
the settings.
To Next Page
Loading...