Application Software
5-19
Span Settings
The Span Settings window enables the setting of the Span parameters.
Click "Span Settings" in "Meas. Parameter Settings" in "Settings" on the menu bar, or click to display the
Span Settings window as shown below. Set the parameters and click "OK".
CHECKPOINT
The Span Settings window contains the same details as those shown on the WR300 monitor screen. For details, see
Section 3.2, "Amp Settings".
CH * to CH * ................... Displays the amplifier units mounted in the WR300. Select the number of the
amplifier unit to be set.
Lower/Upper [Unit] ......... Sets the span upper/lower limits and units for each channel. Click to display the
setting window.
Reverse.......................... Displays the waveform with the span upper/lower limits reversed.
EU Settings
The EU Settings window enables the setting of the Engineering Unit parameters.
Click "EU Settings" in "Meas. Parameter Settings" in "Settings" on the menu bar, or click to display the
EU Settings window as shown below. Set the parameters and click "OK".
CHECKPOINT
The EU Settings window contains the same details as those shown on the WR300 monitor screen. For details, see
Section 3.8, "EU Settings".
CH * to CH * ................... Displays the amplifier units mounted in the WR300. Select the number of the
amplifier unit to be set.
CH * ............................... Selects the channel for scaling conversion. This is on when checked.
Meas. Value Input .......... Lower/Upper Unit
Sets the upper and lower limits for the input signal. Click to display the setting
window.
EU Output ...................... Lower/Upper Unit
Sets the value to be converted. Click to display the setting window.
To Next Page
Loading...