5-20
Application Software
Format Settings
The Format Settings window enables the setting of the waveform display format.
Click "Format Settings" in "Meas. Parameter Settings" in "Settings" on the menu bar, or click to display
the Format Settings window as shown below. Set the parameters and click "OK".
CHECKPOINT
The Format Settings window contains the same details as those shown on the WR300 monitor screen. For details,
see Section 3.7, "Format Settings".
Chart Speed ................... Selects the chart speed for the window displayed.
Output Ratio ................... Sets the expansion/compression ratio along the time axis to replay data. The ratio
is selectable from 1, 1/2, 1/4, 1/5, 1/8, 1/10, 1/20, 1/40, 1/50, 1/80, 1/100, and full-
screen width.
Grid ................................ Selects the grid type displayed on the screen. The grid can be selected from 10 div
Fine, 10 div Coarse, or None.
CH * to CH * ................... Displays the channel group for setting.
• Color ....................... Sets the waveform display color for each channel. Click to display the setting
window.
• Zone Settings ......... Sets the zone start position and display width for the waveform displayed. Click
to display the setting window.
Logic .............................. Sets the logic channel displays when a logic amplifier is mounted.
• Use Logic................ Check this box when using a logic amplifier.
• On ........................... Sets on or off for each logic group. To select "On", check the box.
• Color ....................... Sets the waveform display color for each logic channel. Click to display the
setting window.
CHECKPOINT
These settings will be reset to the default values if the network/USB connection is reset. To store the display colors in
the system, use "Default Color Settings" described earlier.
To Next Page
Loading...