Application Software
5-25
Cursor Functions
The cursors can be displayed as follows. The cursor position is indicated by the digital readout on the right-
hand side of the screen.
(1) First cursor
Either click the mouse on the measurement data display area, or click "Start Readout" in "Replay" on the
menu bar and then click "Select Cursor 1 or 2" in "Cursor selection" in "Start Readout" in "Replay" or
click . The cursor is moved by dragging with the mouse.
(2) Second cursor
Select the cursor number not yet selected in "Cursor selection" in "Replay" on the menu bar. Move the
cursor by dragging with the mouse after selecting the cursor number in "Cursor selection" in "Replay" on
the menu bar.
TIP
To quit the cursor display, either click "End Readout" in "Replay" on the menu bar, or click .
Searching and Jumping to Specific Points
This section describes how to search through cursor-displayed data.
(1) Display the Search window.
Click "Search" in "Replay" on the menu bar or click to display the Search/Jump window.
(2) There are three search methods: Level, Date/Time (Time Jump) and Measured Point (Position Jump).
Search: Level Search
Click the Details button in the above window to display the Level Search window
Combination............ Selects the method for satisfying the Level condition
• OR ................... Searches for the position where a single channel among the target channels
satisfies the search condition
• AND ................. Searches for the position where all of the target channels satisfy the search
condition.
To Next Page
Loading...