GRAPHTEC WR300 - Checking the Outer Casing; Checking the Accessories

2-2
Checks and Preparation
2.1 Checking the Outer Casing
After unpacking, check the WR300/310's outer casing before use. In particular, please check for the
following:
• Surface scratches
• Other flaws such as stains or dirt
2.2 Checking the Accessories
After unpacking, check that the following standard accessories are included. The accessories included will
differ depending on the model purchased.
Thermal paper
1 roll
Roll paper bobbins
2
REMOTE connector
1
CD-ROM
1
Roll length: 40 m
Contains: User’s Manual, Application Software
AC cable (RSC-110)
1
QuickStart Guide
2
Probe set (RIC-10) 4-ch models: 1 of each, 8-ch models: 2 of each, 16-ch models: 4 of each
Logic input cable (RIC-07) Alligator-clip cable (RIC-08) IC-clip cable (RIC-09)
LCD Protector
1
Standard Accessories
DC power cable (RIC-140)
1
Fuse
2
Z-fold chart paper
1 pack
10-pin round connector
Chart paper length: 40 m
Slow-blow type
12V unit: 20A
When the DC drive unit is included
Additional Accessories
Z-fold chart paper (PZ231A)
1 pack
Long-length pipe
1
Chart paper length: 100 m
When the internal Z-fold chart paper unit is included
When the long-length Z-fold chart paper unit is included
Options
4ch : PR230(100 mm)
8/16ch : PR231A(200 mm)
4ch : PZ230(100 mm)
8/16ch : PZ233(200 mm)
Standard Accessories, Thermal paper (PR231A/PR231A), Roll paper bobbins, REMOTE connector, LCD Protector, CD-ROM, User's Manual, Application Software, QuickStart Guide, AC cable (RSC-
110), Additional Accessories, DC power cable (RIC-140), Fuse, Z-fold chart paper (PZ231A), Long-length pipe, Z-fold chart paper (PZ230/PZ233), Options, Probe set (RIC-10), Logic input cable
(RIC-07), Alligator-clip cable (RIC-08), IC-clip cable (RIC-09)