2-14
Checks and Preparation
Loading Z-fold Paper Internally (Option)
(1) Lower the printer open lever and open the printer cover.
(2) Pull the paper's leading edge out of the chart paper outlet of the internal Z-fold unit.
PZ233: 200-mm width Z-fold paper
for WR300-8, WR300-16, WR310-8, WR310-16
PZ230: 100-mm width Z-fold paper for WR300-4
B-524: 100-mm width internal Z-fold paper unit
for WR300-4
B-523: 200-mm width internal Z-fold paper unit
for WR300-8, WR300-16, WR310-8, WR310-16
CAUTION
• When using an internal Z-fold unit, use PZ230 or PZ233 Z-fold paper.
• Recording cannot be performed unless the chart paper's thermal-sensitive surface contacts the thermal head.
Be sure to load the chart paper correctly.
(3) Mount the Z-fold paper unit in the recorder. At this time, make sure that there is sufficient paper to
extend past the printer cover.
High Temperature
Right after recording, the thermal head may be very hot and cause burns or other injuries if accidentally touched.
Before replacing the chart paper, allow the thermal head to adequately cool down.
CAUTION
When loading the chart paper, take care not to damage the thermal head. Recording will not be performed
correctly if the thermal head is damaged.
(4) Pull the leading edge of the paper out of the printer cover's paper outlet, and then close the printer cover
firmly.
To Next Page
Loading...