Recorder Mode
3-7
CHECKPOINT
The span can be physically set to anywhere between -270.0°C to +2000°C regardless of
the temperature range that has been set. However, the actual span that can be used for
each range is shown in the above table.
Notes on Logic
(9) Logic ......................... Can only be set when the logic amplifier is installed. Sets the logic amplifier to
"Enable" (used) or "Disable" (not used).
CHECKPOINT
Logic signals can only be displayed and printed when this setting is enabled and the
"Logic zone" setting is "On" in the Format Settings window.
(10) Threshold................ Can only be set when the logic amplifier is installed. Sets the logic signal High/Low
level threshold values.
+1.4 V (TTL) : High level only when a logic signal greater than approximately
1.4 V is input.
+2.5 V (CMOS) : High level only when a logic signal greater than approximately
2.5 V is input.
+5.0 V (Contact) : High level only when a logic signal greater than approximately
5.0 V is input.
To Next Page
Loading...