GRAPHTEC WR300 - FFT Menu Tree Structure

4-2
FFT Mode
4.1 FFT Menu Tree Structure
Menu Item Details Section
1. Amp. Settings AMP Same as Recorder mode [Amp. Settings] 3.2
Input
Range
Filter
Misc.
2. Memory Settings Common Settings Capture Destination Fixed to Memory 3.3
Sampling Interval
Time Scale Not used
Data Memory Settings Block Size
Capture Time Not used
Memory Chain
Calculation Processing Not used
Capture Block
Auto Save Not used
3. Trigger Settings Common Settings Function 3.4
Time Gate
Action
Trigger Display Point Not used
Start Condition Source
4. Record Settings Record Settings Frequency 4.3
Counts
Window
Average Mode
Ave. Count
Display Format
Grid
Zone Function
Ch. A/B
X/Y
RMS
Ch. A Calc.
Ch. B Calc
5. Data Replay Settings Replay Source Settings Replay Source 3.6
Replay Block Displayed when Memory
File Name Displayed when Disk
Replay Conditions Sampling Interval Displayed when Memory
Time Scale
Count
Replay View Settings Not used
Data Save
Replay Source Settings Replay Source
File Name
6. Format Settings No menu available for Format Settings
7. EU Settings* No EU Settings menu available in FFT mode 3.8
8. Annotation Settings* No Annotation Settings menu available in FFT mode 3.9
9. Calculation Settings* No Calculation Settings menu available in FFT mode 3.10
10. System Settings* No System Settings menu available in FFT mode 3.11
11. Option Settings* No Option Settings menu available in FFT mode 3.12
12 Customize Settings* No Customize Settings menu available in FFT mode 3.13
13.System Information* No System Information menu available in FFT mode 3.14
* Some of the menu contents are the same as those of the Recorder mode. Please refer to Chapter 3, Recorder Mode, for details. Please note that
there are some settings that cannot be made in FFT mode, even if there are explanations provided in Chapter 3.
Disk
Memory