Recorder Mode
3-21
(6) Zone ......................... Selects the display and recording formats for each channel. If you have selected a
preset format using Zone Preset and then make specifications for Zone, the Preset
display will automatically switch to the Custom display.
TIP
The Zone settings enable you to specify display and recording at any location, which
means that you can freely overlap waveforms. In addition, you can specify the start point
as xx mm from the bottom of the chart paper, and then specify the waveform recording
width from that point.
< Example of Zone Settings > 100-mm wide chart paper
CH No. Zone Specification
(4 channels)
1 0-20 [mm]
2 20-10 [mm]
3 30-50 [mm]
4 50-50 [mm]
200-mm wide chart paper
CH No. Zone Specification
(8, 16 channels)
1 0-40 [mm]
2 40-20 [mm]
3 60-100 [mm]
4 100-100 [mm]
4
3
2
1
(7) Color ......................... Selects the color of waveform display for each channel. Besides 32 existing colors
to choose from, you can also create an original color. In this case, a submenu for
color editing appears.
(8) Width ........................ This parameter selects the line width for waveform recording according to channel.
(only when the optional printer is installed printer function has been enabled)
1 dot (about 0.125 mm) to 8 dots (about 1 mm)
CHECKPOINT
Depending on the signal input, recording may not be possible at the selected Width
setting.
(9) Trace......................... Selects the on/off status of waveform display and recording.
(10) Logic Zone .............. This parameter can only be used when Logic has been enabled in the Amp
Settings window. It selects the display and recording zones for logic waveforms
and the line color for displaying the waveforms by Logic Group. Zones from 1 to 10
can be specified. The Color setting can be set to one of 32 colors. It is also
possible to create an original color besides the existing 32 colors. In this case, a
submenu for color editing appears.
< Logic Zone Setting example >
Logic Group A : Zone 1
B : Zone 6
C : Zone 7
D : Zone 9
Zone1
Zone2
Zone3
Zone4
Zone5
Zone6
Zone7
Zone8
Zone9
Zone10
CHECKPOINT
The screen display appears as shown above, but if it is printed out on chart paper, the
positions in the upper half of the display become zone setting positions.
To Next Page
Loading...