Haas VF Series Operator's Manual

10
INSTALLATION
June 1999
96-8000
MOVING T HE C RATE
CAUTION!
THE VMC CRATE CAN ONLY BE MOVED WITH A FORKLIFT.
CAUTION! The fork positions are marked on the crate. (Also, note that there are three skids at each side of
the pallet. The heavy part of the machine [the back] is positioned over the two skids that are closest together.)
If the fork positions are ignored, there is a good chance that the retaining bolts will be sheared off by the forks
and also that the machine will tip over when it is picked up.

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)