2
INSTALLATION
June 1999
96-8000
1. INSTALLING THE VMC
GENERAL WARNINGS
It is the shop operatorîš’s responsibility to make sure that everyone who is involved in installing and operating the
Vertical Machining Center (VMC) is thoroughly acquainted with the installation, operating, and safety instruc-
tions provided with the machine BEFORE they perform any actual work.
NOTE: The ultimate responsibility for safety rests with the shop operator and the
individuals who work with the machine.
The electrical power must meet the specifications in this manual. Attempting to run the VMC from any other
source can cause severe damage and void the warranty.
DO NOT press POWER UP/RESTART on the control panel until after the installation is complete.
DO NOT attempt to operate the machine before all of the installation instructions have been completed.
Observe all of the warnings and cautions in the "Installation" section of the operation manual.
Move the crated VMC with care îš— position forklift forks only as specified by the marks on the crate and the
instructions in this manual.
NEVER service the VMC with the power connected.
NEVER leave the control boxes open when the power is on. A deadly high voltage may be present in ALL
areas of the control boxes.
IMPORTANT!!! Once the machine is installed, the control cabinet must be locked and the key given to the
shop manager.
IF YOU ARE INSTALLING AN APC WITH YOUR MILL PLEASE REFER TO THE APC SECTION OF THIS
MANUAL FOR COMPLETE INSTALLATION INSTRUCTIONS.
To Next Page
Loading...
Need help?
General
