Haas VF Series Operator's Manual

3
INSTALLATION
June 1999
96-8000
OPERATING D IMENSIONS
GNITAREPOE/O-FVTXE/EO-FV1-FV2-FV3-FV4-FV04/5-FV05/5-FV
).ni(thgieH7017015.4015.4015.7115.7112.8115.621
).ni(htdiW901901831901831831841841
).ni(htpeD731731751731751751361361
).bl(thgieW000,7009,7001,7000,8005,21003,31005,41006,41
6-FV7-FV8-FV9-FV01-FV11-FVrepaT05
).ni(thgieH421421421421421421831
).ni(htdiW871091871091552752---
).ni(htpeD061061671671061871---
).bl(thgieW000,12000,32000,42000,52000,82004,92---
NOTE: The operating dimensions are the maximum dimensions of the machine
during operation. These are the dimensions of the machine with the control
panel door completely open, the spindle head at it's highest point, the control
at it's most forward position, and with the discharge tube installed.
etarCfotuO2/1/O-FV4/3-FV04/5-FV05/5-FV6-FV
).ni(thgieH19201101501701
).ni(htdiW88521731731651
).ni(htpeD39695.895.8969
etarCfotuO
7-FV8-FV9-FV01-FV11-FV
).ni(thgieH701701701701701
).ni(htdiW381651381752752
).ni(htpeD6971171169711

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)