120 96-8000
June 1999
OPERATION
When the end of the DNC program is received, the message DNC END FOUND is displayed. When the DNC
program is finished running, the PROGRAM DISPLAY will show the last few lines of the program. You must
press RESET or exit the DNC mode before you can run any other programs. If you try to press START before
RESET of the previous DNC, you will get the message: RESET FIRST.
There are several restrictions on what can be in a DNC program. An M98 Pnnn may not be programmed to
jump to another part of your program. An M30 is not allowed as it is not possible to start over at the beginning.
The program must begin with a % just like any other program sent from the floppy disk and the program must
end with a %.
When DNC is running, BACKGROUND EDIT is not available.
In order to run Graphics, you must first select DNC mode, then go to the graphics display, and enter a file
name and press F3.
To Next Page
Loading...
Need help?
General
