Haas VF Series Operator's Manual

275
PARAMETERS
June 1999
96-8000
Parameter 31 Z D GAIN
See Parameter 3 for description.
Parameter 32 Z I GAIN
See Parameter 4 for description.
Parameter 33 Z RATIO (STEPS/UNIT)
See Parameter 5 for description.
Parameter 34 Z MAX TRAVEL (STEPS)
See Parameter 6 for description.
Parameter 35 Z ACCELERATION
See Parameter 7 for description.
Parameter 36 Z MAX SPEED
See Parameter 8 for description.
Parameter 37 Z MAX ERROR
See Parameter 9 for description.
Parameter 38 Z FUSE LEVEL
See Parameter 10 for description.
Parameter 39 Z BACK EMF
See Parameter 11 for description.
Parameter 40 Z STEPS/REVOLUTION
See Parameter 12 for description.
Parameter 41 Z BACKLASH
See Parameter 13 for description.
Parameter 42 Z DEAD ZONE
See Parameter 14 for description.
Parameter 43 A SWITCHES
See Parameter 1 for description AND make sure that this parameter is se to enable the fourth
axis before you try to enable the fourth axis from settings.
Parameter 44 A P GAIN
See Parameter 2 for description.
Parameter 45 A D GAIN
See Parameter 3 for description.

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)