Haas VF Series Operator's Manual

280
PARAMETERS
June 1999
96-8000
Parameter 78 GEAR CH REV TIME
Time in milliseconds before motor direction is reversed while in a gear change.
Parameter 79 SPINDLE STEPS/REV
Sets the number of encoder steps per revolution of the spindle. Applies only to rigid tapping
option.
Parameter 80 MAX SPIN DELAY TIME
The maximum delay time control will wait for spindle to get to commanded speed or to get to
zero speed. Units are milliseconds.
Parameter 81 M MACRO CALL O9000
M code that will call O9000. Zero causes no call.
Parameter 82 M MACRO CALL O9001
Same as 81
Parameter 83 M MACRO CALL O9002
Same as 81
Parameter 84 M MACRO CALL O9003
Same as 81
Parameter 85 M MACRO CALL O9004
Same as 81
Parameter 86 M MACRO CALL O9005
Same as 81
Parameter 87 M MACRO CALL O9006
Same as 81
Parameter 88 M MACRO CALL O9007
Same as 81
Parameter 89 M MACRO CALL O9008
Same as 81
Parameter 90 M MACRO CALL O9009
Same as 81
Parameter 91 G MACRO CALL O9010
G code that will call O9010. Zero causes no call.
Parameter 92 G MACRO CALL O9011
Same as 91

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)