316
ALARMS
June 1999
96-8000
231 Jog Handle Transition Fault Same as alarm 224.
232 Spindle Transition Fault Same as alarm 224.
233 Jog Handle Cable Fault Cable from jog handle encoder does not have valid differential
signals.
234 Spindle Enc. Cable Fault Cable from spindle encoder does not have valid differential
signals.
235 Spindle Z Fault Encoder marker pulse count failure. This alarm usually indicates
that the encoder has been damaged and encoder position data
is unreliable. This can also be caused by loose encoder
connectors.
236 Spindle Motor Overload This alarm is generated in machines equipped with a Haas
vector drive, if the spindle motor becomes overloaded.
237 Spindle Following Error The error between the commanded spindle speed and the
actual speed has exceeded the maximum allowable (as set in
Parameter 184).
240 Empty Prog or No EOB DNC program not found, or no end of program found.
241 Invalid Code RS-232 load bad. Data was stored as comment. Check the
program being received.
242 No End Check input file for a number that has too many digits
243 Bad Number Data entered is not a number.
244 Missing ) Comment must end with a " ) ".
245 Unknown Code Check input line or data from RS-232. This alarm can occur
while editing data into a program or loading from RS-232. See
MESSAGE PAGE for input line.
246 String Too Long Input line is too long. The data entry line must be shortened.
247 Cursor Data Base Error Software Error; Call your dealer.
248 Number Range Error Number entry is out of range.
249 Prog Data Begins Odd Possible corrupted program. Save all programs to floppy disk,
delete all, then reload.
250 Program Data Error Same as alarm 249.
251 Prog Data Struct Error Same as alarm 249.
252 Memory Overflow Same as alarm 249.
To Next Page
Loading...
Need help?
General
