Haas VF Series Operator's Manual

424
OPTIONS
96-8000
June 1999
19. Pull the pallets onto the friction blocks and against the hard stop (see Figure 11.27). Rotate the
chain slightly, using the chain position adjustment tool, to allow each drive leg pawl to clear the
chain drive roller.
Figure 11.27 View of APC base showing friction block and hard stop.
20. Power OFF the VMC. WARNING! This will cause the automatic door to fall. Keep hands
clear. Remove the jumper from the Fifth Axis (B) port on the side of the VMC control cabinet (see
Figure 11.16), and insert the APC amphenol connector into this port. Tie-wrap the cable to the
door switch cable and the air hoses at the rear of the VMC.
21. Screw the air blast hose into the APC. Remove the piece of tubing from the top fitting of the VMC
lube/air panel cross fitting, and replace it with the APC air hose (see Figure 11.28).
Figure 11.28 APC air hose connection to VMC air/lube cross fitting.

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)