Haas VF Series Operator's Manual

44
INSTALLATION
June 1999
96-8000
3. If the machine is improperly phased perform the following procedure:
a. Make sure there is no power at the input side (top) of the main circuit breaker.
MEASURE THE VOLTAGE!
b. Exchange any two wires at the input side (top) of the main circuit
breaker as shown.
c. Close the control box.
d. Return to Step 1 and test for proper phasing.

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)