12 Safety instructions
HBM QuantumX
Conditions on site
For modules in housings with IP20 degree of protection:
− Protect the modules from moisture and dampness or weather such as rain, snow, etc.
− The permissible relative humidity at 31
o
C is 80% (non condensing); linear reduction to
50% at 40
o
C.
− Make sure that you do not cover the ventilation openings at the side.
For all modules:
− Do not expose the modules to direct sunlight
− Comply with the maximum permissible ambient temperatures as stated in the
specifications.
− Ensure sufficient ventilation during installation into the BPX001 backplane.
Maintenance and cleaning
The modules are maintenance−free. Please note the following points when cleaning the
housing:
− Before cleaning, disconnect the device from all connections.
− Clean the housing with a soft, slightly damp (not wet!) cloth. Never use solvent as this
could damage the labeling or the housing.
− When cleaning, ensure that no liquid gets into the module or connections.
To Next Page
Loading...
