15Introduction
HBMQuantumX
S MX1615 bridge amplifier
The module has 16 individually configurable inputs for strain gauges in quarter-, half- and
full-bridge configuration. DC or carrier-frequency (600 Hz) bridge excitation.
S Data recorder CX22 / CX22−W (WLAN)
The module is used for local recording of measured data.
The modules have the following in common:
S Low voltage connection
S Ethernet interface for data communication with an operating PC
S 2 FireWire interfaces
− For optional voltage supply (see data sheet)
− For optional data communication via PC
− For medule synchronization
− For internal transmission of measurement data
S Connector (VG strip) for installation on an active module carrier (not applicable for P
variants)
S Status LEDs for displaying general system and channel states
S A working standard calibration certificate has been stored on every amplifier. It can be
read out via QuantumX Assistant.
S AutoBoot (module configuration is retained)
With amplifiers, the following applies for each measurement channel:
S Electrical isolation (signal inputs/outputs, voltage supply, communication) for active
sensors
S Configurable supply voltage for active sensors
S Support for TEDS
*)
technology (read, write)
S Configurable sampling rate
S Configurable active digital filter (Bessel, Butterworth)
S Configurable Scaling (can also be saved to the TEDS)
Sensors assigned via the sensor database can be measured (calibrated) via the channel and
rewritten to the sensor database.
*)
TEDS = Transducer Electronic Data Sheet
To Next Page
Loading...
