HEIDENHAIN ITNC 530 - Page 213

HEIDENHAIN iTNC 530 213
5.2 Tool data
Deleting marked tool data
Using this function you can simply delete tool data that you no longer
need.
Follow the steps outlined below for deleting:
 In the tool management you use the arrow keys or mouse to mark
the tool data that you wish to delete
 Press the DELETE MARKED TOOLS soft key. The TNC shows a
pop-up window listing the tool data to be deleted
 Press the START soft key to start the deletion process: The TNC
shows the status of the delete process in a pop-up window
 Terminate the deletion process by pressing the END key or soft key
 The TNC deletes all the data of all the tools selected.
Make sure that you really no longer need the tool data,
because there is no Undo function available.
 You cannot delete the tool data of tools still stored in
the pocket table. First remove the tool from the
magazine.