5 June 2020 CasTemp Wireless including CasTemp Superheat Page 26
• When more than one QUBE CTW module is found actively sending discovery messages, the
CasTemp Wireless instrument will report it and refuse the pairing until only one QUBE CTW
module is active anymore. This is done to prevent pairing with the wrong QUBE CTW module.
• The text of Figure 28 is displayed.
Figure 28: Multiple QUBE CTW modules detected during pairing
4.2.3 Stopping a measurement
A measurement is ended by breaking the link between the CasTemp Wireless instrument and the
QUBE CTW module. There are a number of ways to break this link:
4.2.3.1 Push the button on the CasTemp Wireless instrument
When a measurement is ongoing, the pairing can be broken – and thus the measurement will be
stopped – by pushing the button, see Figure 20: CasTemp Wireless progress bar on the CasTemp
Wireless instrument (for a minimum of 1 second). The CasTemp Wireless instrument will display the
text of Figure 29 to ask for confirmation of the unpairing. After the confirmation, the link between the
CasTemp Wireless instrument and the QUBE CTW module is broken and the measurement ends.
This feature can be disabled in the settings, see section 4.2.4.Prevent unpairing on the instrument
Figure 29: Confirmation of the breaking of the pairing
To Next Page
Loading...
