Heraeus Electro-Nite CasTemp Wireless - CasTip Parameters Adjustment; Checkmate Measurement Functionality

5 June 2020 CasTemp Wireless including CasTemp Superheat Page 35
Figure 40: CasTip Settings
Setting
Default
Comment
Display checkmate
measurement
UNCHECKED
Check this if you would like the CasTip measurement to be
displayed on the SH screen during casting - this will be displayed in
yellow for the amount of time set below - this will not be used to
calculate SH or run a prediction
Display checkmate
measurement time
1
See above
Evaluation window
20
Contact local HEN rep for advice.
Fixed measurement
time
25
Contact local HEN rep for advice.
immersion time
5
Contact local HEN rep for advice.
Qube sleep timeout
60
How long it takes for the QUBE CasTip to go to sleep after
measurement is complete, set to 0 for the QUBE CasTip to always
be awake