5 June 2020 CasTemp Wireless including CasTemp Superheat Page 13
Please see the table below for notes on these inputs:
This must be 8 bytes in length so “12345678”
you can input shorter lengths but these must
start with spaces e.g. “ 123” this example
has 5 spaces in front of the heat number
This can be minute value from 0 to 1000 but
must be in minutes remaining format. E.g. 15
This can be set as °C or °F
this has two options – ready/not ready
Use the format shown above
Note that altering time and date will temporarily disrupt the trace visibility and SH prediction, so
changing this is not recommended.
The tool will remain connected if the instrument is unpaired, and if the network cable is disconnected
and reconnected, and even if the instrument is rebooted. It may take a short time for the connection to
re establish after re boot.
More than 1 instance of the plant simulation tool may be opened and connected to the same server,
and more than 1 server opened on the instrument, connected to a different port
To Next Page
Loading...
