DS-76xx-I2/xP/4S NVR UM
107
1) Go to System > Event > Smart Event.
2) Click Region Exiting.
Figure 12-7 Region Exiting Detection
3) Select a Camera to configure.
4) Check Enable Region Exiting Detection.
5) Optionally, check Save VCA Picture to save the captured pictures of region exiting detection.
6) Select Target Detection as Human Body or Vehicle.
Human Body: Discard non-human body pictures and videos which are not triggered by
region exiting detection.
Vehicle: Discard non-vehicle pictures and videos which are not triggered by region exiting
detection.
7) Follow the steps to set the detection rules and detection areas.
1) Select an Arming Region to configure. Up to 4 regions are selectable.
2) Drag the sliders to set Sensitivity.
Sensitivity: The higher the value is, the more easily the detection alarm can be
triggered. Its range is [0-100].
3) Click Draw Region and draw a quadrilateral in the preview window by specifying four
vertexes of the detection region.
8) Set the arming schedule. Refer to
Chapter 11.1 Configure Arming Schedule
.
9) Set the linkage actions. Refer to
Chapter 11.2 Configure Alarm Linkage Actions
.
10) Click Apply.
To Next Page
Loading...
Need help?
General
