DS-76xx-I2/xP/4S NVR UM
99
3) Select the excetion type from the drop-down list to set the linkage actions.
Figure 11-11 Exceptions Handling
4) Set the normal linkage and alarm output triggering. Refer to Chapter 10.2 Setting Alarm
Linkage Actions.
Trigger or Clear Alarm Output Manually
Purpose:
Sensor alarm can be triggered or cleared manually. When the Manually Clear is selected for the dwell
time of an alarm output, the alarm can be cleared only by clicking the Clear button.
1) Go to System > Event >Normal Event > Alarm Output.
2) Select the alarm output you want to trigger or clear.
3) Click Trigger/Clear to trigger or clear an alarm output.
To Next Page
Loading...
Need help?
General
