DS-76xx-I2/xP/4S NVR UM
128
Figure 16-9 SNMP Settings
2) Check Enable. A message will pop up to prompt possible security risk and click Yes to continue.
3) Configure the SNMP settings as needed.
Trap Address: IP address of the SNMP host.
Trap Port: Port of the SNMP host.
4) Click Apply.
Configure E-mail
Purpose
The system can be configured to send an E-mail notification to all designated users when a specified
event occur, such as an alarm or motion event is detected, or the administrator password is changed,
etc.
Before You Start
The device must be connected to a local area network (LAN) that contains an SMTP mail server. The
network must also be connected to either an intranet or the Internet depending on the location of the
e-mail accounts to which you want to send notification.
1) Go to System > Network > Advanced > E-mail.
To Next Page
Loading...
Need help?
General
