DS-76xx-I2/xP/4S NVR UM
94
Figure 11-5 Set Video Loss Detection
2) Select the camera to configure the video loss detection.
3) Check Enable.
4) Set the arming schedule.
Refer to Chapter 11.1 Configure Arming Schedule
.
5) Set the linkage actions.
Refer to Chapter 11.2 Configure Alarm Linkage Actions
.
Configure Video Tampering Alarm
Purpose:
The video tampering detection enables to trigger alarm when the camera lens is covered and take
alarm response action(s).
1) Go to System > Event > Normal Event > Video Tampering.
2) Select the camera to configure video tampering detection.