DS-76xx-I2/xP/4S NVR UM
113
3) Select a Camera to configure.
4) Check PIR Alarm.
5) Optionally, check Save VCA Picture to save the captured pictures of PIR alarm.
6) Set the arming schedule.
Refer to Chapter 11.1 Configure Arming Schedule
.
7) Set the linkage actions.
Refer to Chapter 11.2 Configure Alarm Linkage Actions
.
8) Click Apply.
Enable Smart Analysis
Purpose
Smart search can be enabled for IP cameras that do not support line crossing and intrusion detection,
and allow for line crossing and intrusion events to be analyzed. Smart events will be changed after
enabling Smart Analysis.
1) Go to System > Event > Smart Event.
2) Check Enable Smart Analysis.
3) Click Yes on popup message box.
To Next Page
Loading...
