DS-76xx-I2/xP/4S NVR UM
96
Figure 11-7 Alarm Input
3) Select the alarm input type to N.C or N.O.
4) Edit the alarm name.
5) Check the radio button of Input.
6) Set the arming schedule. Refer to
Chapter 11.1 Configure Arming Schedule
.
7) Set the linkage actions. Refer to
Chapter 11.2 Configure Alarm Linkage Actions
.
8) Click Apply and follow the message box to reboot device to take effect the settings.
Configure One-Key Disarming
One-key disarming enables the device to disarm an alarm input by one-key operation.
1) Go to System > Event > Normal Event > Alarm Input
2) Select the alarm input1 item from the list and click.
3) Change the alarm input type to N.C or N.O.
4) Edit the alarm name.
5) Check the Enable One-Key Disarming radio button.
To Next Page
Loading...
