DS-76xx-I2/xP/4S NVR UM
69
One-Touch Creation
Purpose
One-touch configuration helps you to quickly create the disk array. By default, the array type created
by one-touch configuration is a RAID 5.
Before you start
Enable RAID function. For details, refer to
Chapter 8.1.1 Enable RAID
.
Install at least 3 HDDs. If more than 10 HDDs are installed, 2 arrays will be created. To maintain reliable and
stable running of the HDDs, it is recommended to use enterprise-level HDDs with the same model and
capacity.
1) Go to Storage > RAID Setup > Physical Disk.
Figure 8-2 Physical Disk
2) Click One-touch Config.
3) Edit the array name in the Array Name text field and click OK to start configuring.
4) A message box will pop up when the array creation is completed. Click OK.
5) Optionally, the device will automatically initialize the created array. Go to Storage > RAIDSetup >
Array view the information of the created arrray.
Manual Creation
Purpose
Manually create the array of RAID 0, RAID 1, RAID 5, RAID 6, and RAID 10.
1) Go to Storage > RAID Setup > Physical Disk.
2) Click Create.
To Next Page
Loading...
Need help?
General
