DS-76xx-I2/xP/4S NVR UM
134
Chapter 18 System Maintenance
Storage Device Maintenance
Configure Disk Clone
Purpose:
Select the HDDs to clone to eSATA HDD.
Before you start:
Connect an eSATA disk to the device.
1) Go to Maintenance > HDD Operation > HDD Clone.
Figure 18-1 HDD Clone
2) Check the HDD to clone. The capacity of selected HDD must match the capacity of clone
destination.
3) Click Clone.
4) Click Yes on popup message box to continue clone.
Figure 18-2 Message Box
To Next Page
Loading...
