DS-76xx-I2/xP/4S NVR UM
106
2) Click Region Entrance Detection.
Figure 12-6 Region Entrance Detection
3) Select a Camera to configure.
4) Check Enable Region Entrance Detection.
5) Optionally, check Save VCA Picture to save the captured pictures of region entrance
detection.
6) Select Target Detection as Human Body or Vehicle.
Human Body: Discard non-human body pictures and videos which are not triggered
by region entrance detection.
Vehicle: Discard non-vehicle pictures and videos which are not triggered by region
entrance detection.
7) Follow the steps to set the detection rules and detection areas.
1) Select an Arming Region to configure. Up to 4 regions are selectable.
2) Drag the sliders to set Sensitivity.
Sensitivity: The higher the value is, the more easily the detection alarm can be
triggered. Its range is [0-100].
3) Click Draw Region and draw a quadrilateral in the preview window by specifying four
vertexes of the detection region.
8) Configure Arming Schedule and Linkage Action.
9) Click Apply.
Region Exiting Detection
Purpose
Region exiting detection function detects objects that exit from a pre-defined virtual region.
To Next Page
Loading...
Need help?
General
