DS-76xx-I2/xP/4S NVR UM
143
Set HTTP Authentication
Purpose
If you need to enable the HTTP service, you can set the HTTP authentication to enhance the access
security.
1) Go to System > System Service > System Service.
Figure 18-13 HTTP Authentication
2) Check the Enable HTTP to enable the HTTP service.
3) Select the digest as the HTTP Authentication in the drop-down list.
4) Click Save to save the settings.
Two authentication types are selectable: digest and digest/basic. For security reasons, it is
recommended to select digest as the authentication type.
Disable HTTP
Purpose
The admin user account can disable the HTTP service from the GUI or the web browser. After the HTTP is
disabled, all its related services, including the ISAPI, Onvif and Genetec, will terminate as well.
1) Go to System > System Service> System Service.
2) Uncheck the Enable HTTP to disable the HTTP service.
RTSP Authentication
Purpose
You can specifically secure the stream data of live view by setting the RTSP authentication.
1) Go to System > System Service> System Service.
Figure 18-14 RTSP Authentication
2) Select the authentication type.
Two authentication types are available: digest and digest/basic. If you select digest, as the RTSP
authentication, only the request with digest authentication can access the video stream by the RTSP
protocol via the IP address. For security reasons, it is recommended to select digest as the
authentication type.
To Next Page
Loading...
Need help?
General
