HIKVISION DS-K1T605 Series - Page 78

6.
Click Save.
•
The congured parameters will be applied to the device
automacally.
•
Aer changing the working mode or connecon mode, the
device will reboot
automacally.
Set Wiegand Parameters
You can set the access control device's Wiegand channel and the
communicaon mode. Aer seng the Wiegand parameters, the
device can connect to Wiegand card reader via Wiegand
communicaon.
Steps
Note
This funcon should be supported by the device.
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon
More Parameters .
3.
Select an access control device in the device list and click
Wiegand to enter the Wiegand Sengs page.
4.
Set the switch to on to enable the Wiegand
funcon for the
device.
5.
Select the Wiegand channel No. and the communicaon mode
from the drop-down list.
Note
If you set Communicaon Direcon as Sending, you are
required to set the Wiegand Mode as Wiegand 26 or Wiegand
34.
6.
Click Save.
•
The congured parameters will be applied to the device
automacally.
•
Aer changing the communicaon direcon, the device will
reboot
automacally.
Enable M1 Card Encrypon
M1 card encrypon can improve the security level of
authencaon.
Steps
Note
The funcon should be supported by the access control device
and the card reader.
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon
More Parameters .
3.
Select an access control device in the device list and click M1
Card
Encrypon to enter the M1 Card Encrypon page.
4.
Set the switch to on to enable the M1 card encrypon
funcon.
5.
Set the sector ID.
The sector ID ranges from 1 to 100.
69