HIKVISION DS-K1T605 Series User Manual

2.
On the navigaon bar on the le, enter Advanced Funcon
More Parameters .
3.
Select an access control device in the device list and click Face
Recognion Terminal.
4.
Set the parameters.
Note
These parameters displayed vary according to dierent device
models.
COM
Select a COM port for conguraon. COM1 refers to the
RS-485 interface and COM2 refers to the RS-232 interface.
Face Picture Database
select Deep Learning as the face picture database.
Authencate by QR Code
If enabled, the device camera can scan the QR code to
authencate. By default, the funcon is disabled.
Blacklist Authencaon
If enabled, the device will compare the person who want to
access with the persons in the blacklist.
If matched (the person is in the blacklist), the access will be
denied and the device will upload an alarm to the client.
If mismatched (the person is not in the blacklist), the access
will be granted.
Save
Authencang Face Picture
If enabled, the captured face picture when
authencang
will be saved on the device.
MCU Version
View the device MCU version.
5.
Click Save.
Set RS-485 Parameters
You can set the access control device's RS-485 parameters
including the baud rate, data bit, the stop bit, parity type,
ow
control type, communicaon mode, work mode, and connecon
mode.
Steps
Note
The RS-485 Sengs should be supported by the device.
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon
More Parameters .
3.
Select an access control device in the device list and click
RS-485 to enter the RS-485
Sengs page.
4.
Select the serial port number from the drop-down list to set
the RS-485 parameters.
5.
Set the baud rate, data bit, the stop bit, parity type,
communicaon mode, working mode, and connecon mode in
the drop-down list.
68

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English